第一范文网 - 专业文章范例文档资料分享平台

USB在动态可重构总线测试系统中的设计

来源:用户分享 时间:2025/8/6 11:10:51 本文由loading 分享 下载这篇文档手机版
说明:文章内容仅供预览,部分内容可能不全,需要完整文档或者需要复制内容,请下载word后使用。下载word有问题请添加微信号:xxxxxxx或QQ:xxxxxx 处理(尽可能给您提供完整文档),感谢您的支持与谅解。

USB在动态可重构总线测试系统中的设计

陕天龙;周继芹;王春亮;张伟功

【期刊名称】《计算机工程与设计》 【年(卷),期】2015(000)002

【摘要】The data transfer rate of UM-BUS can reach 200 Mbps/lane,and the effective bandwidth can reach 149. 5 MB/s at 8 lanes.The channel bandwidth between data acquisition terminal and PC must meet the above requirement.The USB3. 0’s theo-retical transmission rate can reach 5 Gbps,which meets requirement of UM-BUS test system.the design and application of USB3. 0 in the bus test system was put porward.The experimental result show that the USB3. 0 can ensure data transmission running at 180 MB/s.Data’s monitor with no filter and fault injection are both the bus test system’s important functions,the performance of USB3. 0 application lays the foundation of these functions realization.%UM-BUS总线单通道最高通信速率为200 Mbps,采用8通道并发传输时,总线有效带宽可达149.5 MB/s,其测试系统需要在采集终端与PC机之间建立不低于此带宽的通信通道,USB3.0理论传输速率可达5 Gbps,可满足UM-BUS总线测试系统的传输需求,由此设计实现UM-BUS总线测试系统的USB3.0应用方案。实验测试结果表明,该方案实际传输速度可达180 MB/s,为实现UM-BUS测试系统的无过滤监听和故障注入等功能打下了基础。 【总页数】7页(514-519,538)

USB在动态可重构总线测试系统中的设计.doc 将本文的Word文档下载到电脑,方便复制、编辑、收藏和打印
本文链接:https://www.diyifanwen.net/c1bsmc37ent036aw5tvxo0daes3y38300x5l_1.html(转载请注明文章来源)
热门推荐
Copyright © 2012-2023 第一范文网 版权所有 免责声明 | 联系我们
声明 :本网站尊重并保护知识产权,根据《信息网络传播权保护条例》,如果我们转载的作品侵犯了您的权利,请在一个月内通知我们,我们会及时删除。
客服QQ:xxxxxx 邮箱:xxxxxx@qq.com
渝ICP备2023013149号
Top