汽车BCM功能规范

来源：用户分享时间：2025/9/25 5:56:29 本文由

说明：文章内容仅供预览，部分内容可能不全，需要完整文档或者需要复制内容，请下载word后使用。下载word有问题请添加微信号:xxxxxxx或QQ：xxxxxx 处理（尽可能给您提供完整文档），感谢您的支持与谅解。

Function Specification E&E Department EC Team

Vehicle Security Feedback (Visual and audible):

Types of Vehicle Security Turn lights Flash: Feedbacks: Chirp: 50ms 1. Arming 500ms 500 ms 500 ms 2. Disarming No chirp 500ms 500ms 500 ms 1500ms 500ms 500 ms 500ms 500 ms 4. Intrusion 500ms 500 ms 28?2 (s) Always chirp No chirp 3. Arming Fault CHERY EE . All Rights Reserved. Page 21 of 36

Function Specification E&E Department EC Team ? Arming Mode:

- Arming mode is set when all of the following conditions are met ? Doors are locked by RF command And ? Vehicle is in lock state And ? All doors, hood and trunk are closed

- Feedback of Arming mode is set:

? Arming And ? Dome light is off

The vehicle will relock itself when manual unlock is detected during this time.

Function Specification E&E Department EC Team ●

Disarming Mode: -

RF unlock command can disable Arming Mode

If all doors and trunk and hood are close, after 28 ?2(S), the vehicle will rearm itself. But the window auto up function will not be executed in this circumstance. Disarm modeRF Unlock signal Set28s±2s Set Clear28s±2sDisarming Mode Clear0.6s±50ms0.6s±50msUnlockDoor Unlock/Lock Motor ActuatorLockTurn LightsChirp (Siren) On Off On Off On Off0.5s±50ms 0.5s±50ms 0.5s±50ms Security Indicator100ms100ms900ms100ms

Function Specification E&E Department EC Team ? Intrusion Mode (Intrusion is detected):

- Alarm is triggered when any of the following situations happens: ? Any Door or Trunk is opened Or ? Hood is opened Or ? IGN ON

- Siren and Flashing will operate continuously for 28sec ? 2 sec. - If all doors, trunk and hood are detected closed after 28sec (vehicle is considered secured), then the

vehicle will rearm itself. - Alarm will be triggered when any of the above situations occur again.

Note: if T1 present during the Alarm mode, after each cycles, the car comes into the arming mode at once. If keep the intrusion condition unchangeable, the alarm will last 8 cycles totally (each cycle will have a 5s pause).

After alarm 8 cycles, the car comes into waiting for T1 present, if T1 is presenting, the car comes into the arming mode.

(T1: All doors closed and trunk closed and hood closed and IGN OFF).

搜索更多关于：汽车BCM功能规范的文档

汽车BCM功能规范.doc 将本文的Word文档下载到电脑，方便复制、编辑、收藏和打印

下载这篇word文档

本文链接：https://www.diyifanwen.net/c69xcd9icr12wkqq4m2ih_6.html（转载请注明文章来源）